Universal remote instruction manual • Read online or download PDF • GE Universal Remote User Manual. Control Remoto Universal. Manual de. GE/Jasco 4 digit universal remote control code lists for TV sets including LCD, Plasma, and Panel TVs, DVDs, GE V2 sticker GE CL3 sticker. View online or download Ge Instruction Manual. Manuals and User Guides for GE Brand: GE | Category: Remote Control | Size: MB.
|Published (Last):||14 December 2016|
|PDF File Size:||1.38 Mb|
|ePub File Size:||5.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
The following is a short tutorial on programming most models of GE universal remotes with 4 digit codes. See also this page for general GE remote code entering instructions.
The red indicator will blink, then stays lit. Enter the 4 digit code for your device. After a valid code entry, the red indicator turns off.
For an invalid code, the red indicator flashes.
If the device responds, no further programming is required. If some buttons don’t work as they should, try one of the other codes for your brand. To find out the version your remote uses, open the battery compartment, remove cobtrol batteries and locate the sticker containing the model number.
4 digit GE universal remote control codes with code entering instructions
A Version 2 through Version 5 remote will have a “V2” to “V5” after the model number. Older remotes with no version after the model use the V1 code list.
The newest ones will be CL3 or CL4. In order to save you the hassle of going through multiple code tables, we have compiled together the code lists from different versions of GE remotes sharing the same code base e.
You’ll also get the benefit of finding the code for your device even if it appeared after your remote was manufactured, but uses an old code that already exists preprogrammed in your model. The only downside of this approach is, that there will be a few codes that are only supported by a particular version. So, if a code listed for your brand is not supported by your remote, try the next one from the list.
Sometimes a code will be accepted, but only allow limited function control e. In conttol case, continue programming using the next code number for that brand.
The Auto Code Search searches automatically through all of the codes stored in your remote. If your device does not respond to any of the codes listed with your equipment, or your brand is not listed, try the following steps:. Press and hold the “SETUP” button until the red indicator light stays on around 4 seconds and then release the button. The red indicator will blink once and remains codez.
The red indicator will flash approximately every 2 seconds as the remote searches. The remote must be pointed at your device for the entire duration of this search. Place your finger on the 1 button so ccontrol are prepared to lock-in the code. When the device shuts universa or begins playing, press the 1 remoote to lock-in the code.
you’re punching buttons at remotecodelist.com
The red indicator light will turn off. You have approximately two seconds after the cofes shuts off or begins playing to lock-in the code. Point the remote at the device and check to see if the remote operates the device as desired.
If it does, no further programming is required.
If it does not, return to step 2 remotee start the auto search again. The red indicator will blink once, then stays on. The red indicator will blink with each keypress. When all codes have been searched the red indicator flashes rapidly for 3 seconds. The indicator light goes off.
Then follow the steps above for Code Search.